gaz1 Member
replying to lots of people but not using quotes or reply will be a mile long
cameras are good ip rated, and they last a long time, but temperature fluctuates a lot, a few of them are in blast freezers where they're empty, then loaded up and pulled down to -30, few days later it's emptied (and left open) filled again and back down to -30.... leaving them empty so we can load/unload without needing a load of warm gear on
link works for me too now, not sure what was going on
I thought about enclosures but couldn't find any that looked decent or weren’t a fortune
guess I'll just go with a small heater and hope it loses heat quick enough to not get too hot
I assumed there'd be some kind of industry standard low power anti freeze heaters that I just didn't know about
older external cctv cameras might be a better thought as they are designed for really bad external weather
but extreme weather which is what your on about needs a better camera and there not cheap
| # | Наименование новости | Тональность | Информативность | Дата публикации |
|---|---|---|---|---|
| 1 | Генераторы тумана | 0 | 10 | 10-07-2026 |
| 2 | 0 | 0 | 24-10-2018 | |
| 3 | 0 | 0 | 26-10-2018 | |
| 4 | Olas de calor | 0 | 10 | 23-07-2026 |
| 5 | Пюпитры (нотные пульты) | 0 | 10 | 10-07-2026 |
| 6 | Вентиляторы | 0 | 10 | 10-07-2026 |
| 7 | Anyone got / has access to a CNC air bed punch / a simple punch & press able to do15mm holes in 1.5mm stainless flat sheet 400 x 40 x 1.5mm thick ? | 0 | 15.41 | 12-08-2026 |
| 8 | smooth and paint 3d printed stuff ? | 0 | 5 | 07-07-2026 |
| 9 | My first Mig welder? | 0 | 1 | 07-07-2026 |
| 10 | My First Entry in to Installing CH Radiators | 0 | 5 | 07-07-2026 |