Hi all new user here, I'm in the process of converting my migmate 150 dual purpose to a eurotorch, already got the torch installed, now just trying to work out what gas solenoid I need and where to take a power feed from to operate it as it has me stumped atm, if anyone could point me in the correct direction that would be amazing as as I said I am stumped

Need a 240v one - and take power from the board

Welcome mate, you might be stumped at the minute but stick at it, plenty of knowledgeable folk on here, not me though, I have only just qualified to fit a three pin plug!

Need a 240v one - and take power from the board

What points on the board would I use as been trying to find a triggered feed using my multimeter and it hasn't helped in the slightest

Welcome mate, you might be stumped at the minute but stick at it, plenty of knowledgeable folk on here, not me though, I have only just qualified to fit a three pin plug!

That's for the welcome

What points on the board would I use as been trying to find a triggered feed using my multimeter and it hasn't helped in the slightest

Use the feed to the primary of the transformer. That's how I did it when I recently converted my Clarke

Should be where it says t s r - one will be live in and one will be neutral - I think the relay switches neutral for the transformer

Bottom pic is pulled from the net but maybe in this group - so please test first but looking at that I would say you T and R or take live from the on/off switch then the other from T - but please check first .